Building over a kitchen unit with door
Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be hot when in operation. The recommended solution is shown in diagram 3. The panel fitted under the hob ("a") should be easily removable to allow easy access if technical assistance is needed. The space behind the kitchen unit ("b") can be used for connections.
3
a b
60
FO 1013
Dimensions are given in mm.
Fitting the hob to the worktop
Before fitting the hob into the cut out, a sealing gasket supplied with the hob must be fitted to the edge of the cut out. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below.
F
as shown in the diagram.
30
FO 0199
1) Place the sealing gasket all around the edge of the cut out.
3) Remove the excess seal The edge of the hob forms a double seal which prevents the ingress of liquids.
8
20 min
2) Place the hob into the cut out and secure it by means of the relevant fixing clamps and screws,
